So You ve Bought Fiat 500 Replacement Key Cost ... Now What

fiat remote key replacement 500 Replacement Key Fob

It's possible to replace the battery if your 500 remote key fob is not working. If you replace the battery and it isn't working the issue could be elsewhere.

At United Locksmith, we specialize in the creation of new keys for old automobiles. We have the tools and spare parts required for this service.

Dead Coin Battery

The most common reason why your fiat 500 spare key cut 500 key fob will not lock or unlock the doors is a dead battery. The coin cell battery in the key fob will drain quickly when you don't utilize frequently enough. If your remote started to show signs of weakness like a loss of range and stopped working completely the battery could be dead.

The battery inside the key fob is held in place by steel retaining clips. If the clips are not tight, they can cause contact problems that will prevent the remote from receiving power. Use a flathead screwdriver to remove the retaining clip and then remove the old battery. Make sure to use a battery with the same size, voltage and specification as the original.

The key fob may also become corroded or damaged through exposure to water. Even a brief bath in warm, soapy water can cause damage to the chip. It's best to keep your key fob in a dry location.

Water Damage

If your key fob doesn't work properly, it could be due to water damage. The rubber seals on key fobs stop them from getting damaged by a small splash or drizzle of water. However, it is crucial to keep the keys out of the washing machine, ocean, and pool.

The key fob has an electronic chip that sends a signal car's immobilizer system. This is what allows your 500 to lock or start, but should the chip become wet, it will no longer work.

You can try cleaning the inside of your key fob's electronics with isopropyl alcohol or an electronic cleaner to see whether they're still in good condition. It is recommended to replace a key fob if it has been submerged into salt water rather than try to repair it yourself.

While a replacement fob could cost you a bit of money, it's much cheaper than paying for your fiat doblo key programming 500 to be towed to the dealership and repaired! You can also do it yourself by following just a few steps. Just ensure you have the right battery type before you attempt to open your key fob. You can find step-bystep instructions for every car keyfob online.

Faulty Chip

The chip that is contained in the key fob communicates to your car's immobiliser unit to ensure the lost car keys fiat is capable of starting when the correct key is used. If the chip is damaged or corrupted the car won't start, no matter what you do.

A chip that is defective can happen due to a variety of reasons but most often it is due to water damage or the battery being dead. Whatever the reason, it's an ideal idea to hand the job to a locksmith since they will be able to repair the chip for you swiftly and at a cost-effective price.

If your key fob will not work after exposure to clean tap or rain water then remove the battery. Clean the electronic component using paper towels. If the key fob does not work, there is an opportunity that it is malfunctioning components and need to be replaced.

A few people turn to their dealer when they are in need of an entirely new Fiat key fob, but this is a expensive option. If you're looking for a cost-effective way to get your Fiat key fob fixed, look no further than United Locksmith. We have the tools and experience required to repair your Fiat key fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs send signals up 50 feet away to the vehicle, which will unlock and close the doors (and start the vehicle for those with automatic transmissions). There are a few reasons why the fob might stop working. This could be due to a dead coin battery damaged by water, worn buttons as well as a receiver module problem and signal interference, or a malfunctioning electronic chip.

If the fob is in an area that has experienced severe trauma (such as being dropped onto the hard floor or washed in the washing machine) the fob might not be in a position to communicate with the Body Control Module (BCM) of the car. This is because the BCM is secured and will only accept a signal from a genuine key, and not from any other.

If this is the case, then you will require replacing your fob. A professional locksmith can handle the entire key replacement process including programming a brand new key for your 500. In fact, they can provide you with a clone key that works just the same way as the original fob (and costs only a fraction of the price).